Can A Cooling Tower Replace The Outdoor Unit of An Evaporative‑cooling Air Conditioner?｜Key Points Only

Is it feasible to remove the original outdoor unit of an industrial energy‑saving evaporative‑cooling air conditioner and use a cooling tower instead?

Answer: ✅ Yes, it works!

Both the air‑conditioner outdoor unit and cooling tower perform similar functions — they dissipate heat for the compressor refrigerant.

However, there are pitfalls you must avoid when substituting a cooling tower for the outdoor unit

Important Reminder

Common open cooling towers feature an open‑top design. Leaves, dust and debris easily fall into the water, resulting in poor water quality.

If you adopt this setup, clean the cooling tower regularly and maintain clean water to prevent pipeline blockages.

Recommendations for Two Working Conditions

▪ Multiple units installed together

Open or closed cooling towers can be shared for heat dissipation.

▪ Only 1‑2 small‑capacity units

An independent external cooling tower is not recommended. The tower has to run simultaneously whenever the indoor unit is turned on; separate control is unavailable, leading to higher energy consumption and poor cost‑performance. The original factory‑fitted outdoor unit is a better choice.

⚠️ Three critical factors for external cooling tower modification: pressure, flow rate and clean water quality!

Leave a comment if you have questions about evaporative‑cooling air conditioner selection or retrofitting. Follow Lengfengge for practical factory cooling tips